Wireless Technology Quiz 5

• Question 1
1 out of 1 points

A centralized wireless LAN controller maintains how many code image files?
Selected Answer: 2

• Question 2
1 out of 1 points

To save a copy of a controller’s configuration, which of the following methods could you use?
Selected Answer: Use Commands > Upload File

• Question 3
2 out of 2 points

Which two of the following file transfer methods can be used to move a centralized controller code image file onto a controller?
TFTP
FTP

• Question 4
1 out of 1 points

Which one of the following is used to relay DHCP requests from wireless clients?
Selected Answer: Virtual interface

• Question 5
1 out of 1 points

A wireless controller port is used for which one of the following purposes?
Selected Answer: Provide a physical connection to a switch port

• Question 6
1 out of 1 points

Which one of the following correctly describes the single logical link formed by bundling all of a controller’s distribution system ports together?
Selected Answer: LAG

• Question 7
1 out of 1 points

Which one of the following controller interfaces maps a WLAN to a VLAN?
Selected Answer: Dynamic interface

• Question 8
2 out of 2 points

Which of the following methods can you use to perform the initial setup of a wireless LAN controller? (Choose all that apply.)
Selected Answers: CLI
Web browser

• Question 9
1 out of 1 points

To perform an initial configuration of a converged wireless controller, to which one of the following should you connect with your web browser?
Selected Answer: Access switch management address

• Question 10
2 out of 2 points

Suppose you use a web browser to access a controller and make a configuration change. You make sure to click on the Apply button. A short time later, the controller loses power and then reboots. Which two of the following answers correctly describes the result?
The Apply button made the change active, but didn’t save it across the reboot
You would need to click the Save Configuration link to save the change permanently

• Question 11
1 out of 1 points

A CAPWAP tunnel terminates on which one of the following controller interfaces?
Selected Answer: AP-manager interface

• Question 12
1 out of 1 points

Suppose that you have just powered up a new controller. If you connect to the controller’s console port, in which one of the following modes will you find the controller?
Selected Answer: Initial setup mode

• Question 13
1 out of 1 points

Suppose you need to transfer a code image file from a TFTP server on your PC to a controller. Which of the following file copy directions should you choose?
Selected Answer: Download

• Question 14
1 out of 1 points

Which one of the following is used for remote out-of-band management of a controller and the initial controller setup?
Selected Answer: Service port

• Question 15
1 out of 1 points

A distribution system port is usually configured in which one of the following modes?
Selected Answer: 802.1Q trunk

• Question 16
1 out of 1 points

After copying a new code image file to a controller, how should you copy the same code release to the lightweight APs?
Selected Answer: Do nothing; each AP will get the new image as it rejoins the controller